RSW Solutions
RSW Solutions
  • 121
  • 5 759 491
Tire Company Insists Lug Nuts are Unsafe
Sorry for my video rant. I want to get your opinion. Are these lug nuts unsafe or was I correct to stand my ground. In the end the tire company included the lug nuts for free but only after a heated and difficult exchange with service representatives. My experience shows that just about every Land Rover since the 90's has these cosmetic cap lug nuts which can at times present a challenge to remove and refit.
Переглядів: 1 482

Відео

Meade Autostar 497 - Internal GPS Modification - Part 2
Переглядів 45210 місяців тому
Sorry, I know this is not my normal content for this channel. The setup and wiring in part 1 of this video allowed for GPS serial signals to be passed into the normal serial input to the Motorolla 68HC processor. Unfortunately, this will interfere with any attempts to use the normal serial line for other communications, like firmware updates or PC control of the telescope. You must interrupt th...
Meade Autostar 497 - Internal GPS Modification - Part 1
Переглядів 1 тис.10 місяців тому
Sorry, I know this is not my normal content for this channel. This video is for the very small community of persons who own a Meade ETX Telescope and an Autostar 497 controller. In the video, I show how to add a GPS receiver internally to the Meade 497 controller.
Windows 10 - Administrator Block Workaround
Переглядів 1,5 тис.2 роки тому
Some Windows 10 users will receive a message when trying to install the SiLabs drivers. The message states that the administrator has blocked you from running this app. This is a false positive on the Windows UAC protection system. There is nothing wrong with the SiLabs signed drivers. Running the installer from inside a elevated Windows command prompt will bypass the Windows UAC protection sys...
4Dcan Troubleshooting
Переглядів 2,8 тис.5 років тому
How to connect and communicate with the 4Dcan software tool.
Land Rover LR3 - System Too Lean Check Engine Light (P0171 - P0174)
Переглядів 72 тис.5 років тому
Only Use DENSO Sensor 197-6020 as a replacement. I diagnose the faults on an LR3 engine ECU and replace the Mass Air Flow Sensor. Remember that I replaced this sensor after checking the Short Term and Long Term fuel trims. Also made sure that there were no air vacuum leaks in the system. The Short Term and Long term trims were good at idle but all over the place during acceleration. The Delphi ...
RSWsolutions - Range Rover P38 EAS Delay Relay
Переглядів 27 тис.6 років тому
Method for testing the P38 Range Rover 1995-2002 EAS Delay Relay functionality from the OBDII port.
RSW Solutions - All Comms - Body Control Module Debug
Переглядів 7 тис.6 років тому
Steps to restore a Body Control Module Configuration String to the original configuration.
L322 Range Rover - Suspension Noise - FIXED!!
Переглядів 160 тис.6 років тому
I found the source of the clunking noise. Took a step back and started the diagnostic process over again. I eventually isolated the problem to the sway bar link ball joints.
L322 Range Rover - Suspension Noise - Part 3
Переглядів 15 тис.6 років тому
Sorry for the short video. Just an update that the suspension clunking is still present after I replaced the front lower control arm bushings. I will need to do some more investigating. I may also just replace those worn ball joints since I have the parts. I Found the Problem: ua-cam.com/video/FaOwlPCoicM/v-deo.html
L322 Range Rover - Suspension Noise - Control Arms
Переглядів 68 тис.6 років тому
Part 2. We replace the worn control arms on the 2012 L322 Range Rover Chassis. Not sure if this is the entire source of the suspension clunking noises but needed to be replaced. Found the Problem: ua-cam.com/video/FaOwlPCoicM/v-deo.html
L322 Range Rover - Suspensio Noise - Part 1
Переглядів 53 тис.6 років тому
Example: 2:16. Investigate the possible causes of low speed suspension clunking noises from the L322 Range Rover Chassis. The most likely culprit is the Front Suspension, Lower (rearward), Control arm bushing. Lets look closer to make sure something is not right before we start replacing parts. Found the Problem: ua-cam.com/video/FaOwlPCoicM/v-deo.html
Land Rover 5.0 Liter - Timing Chain Guide Problems - Part 2
Переглядів 32 тис.6 років тому
In part 2, we look at failed timing chain guides pulled from a 5.0L Ford manufactured Land Rover engine. This engine is in the 2010-2012 Range Rover, Range Rover Sport and LR4 vehicles. The timing chain guides should be a flat surface at the mating point where the tensioner meets. This mating surface is so worn that a hole has developed.
Range Rover - Leaky Air Spring Replacement - Part 2
Переглядів 7 тис.6 років тому
We move on to the replacement of the front air spring air strut assembly on the 2012 L322 Range Rover
Range Rover - Leaky Air Spring Replacement - Part 1
Переглядів 10 тис.6 років тому
RSW Solutions goes over how to diagnose leaking air springs on a 2012 L322 Range Rover. Next we will replace the air springs.
Land Rover 5.0 Liter - Timing Chain Guide Problems - Part 1
Переглядів 97 тис.7 років тому
Land Rover 5.0 Liter - Timing Chain Guide Problems - Part 1
RSW Solutions - 4Dcan tool Air Suspension Compressor PSI
Переглядів 1,6 тис.7 років тому
RSW Solutions - 4Dcan tool Air Suspension Compressor PSI
RSW Solutions - 4Dcan Programmatic Suspension Lift
Переглядів 2,3 тис.7 років тому
RSW Solutions - 4Dcan Programmatic Suspension Lift
RSW Solutions - L322 Range Rover EAS Calibration
Переглядів 60 тис.7 років тому
RSW Solutions - L322 Range Rover EAS Calibration
Land Rover - Range Rover - Head Gasket Replacement
Переглядів 156 тис.7 років тому
Land Rover - Range Rover - Head Gasket Replacement
Range Rover - MagnaFlow 16899 - Install and Sound
Переглядів 11 тис.8 років тому
Range Rover - MagnaFlow 16899 - Install and Sound
Windows 10 Driver Problem
Переглядів 48 тис.8 років тому
Windows 10 Driver Problem
Using a Tablet with RSW Solutions Software
Переглядів 3,4 тис.9 років тому
Using a Tablet with RSW Solutions Software
Range Rover P38 - Never Trust A Relay
Переглядів 120 тис.9 років тому
Range Rover P38 - Never Trust A Relay
Range Rover P38 - FuseBox Repair
Переглядів 21 тис.9 років тому
Range Rover P38 - FuseBox Repair
Range Rover P38 - Blower Motor Repair
Переглядів 53 тис.9 років тому
Range Rover P38 - Blower Motor Repair
EASunlock V4 - HEVAC Diagnostics
Переглядів 6 тис.9 років тому
EASunlock V4 - HEVAC Diagnostics
RSW Solutions - P38 Range Rover Valve Block Rebuild
Переглядів 42 тис.9 років тому
RSW Solutions - P38 Range Rover Valve Block Rebuild
RSW Solutions - If Possible Always buy OEM
Переглядів 2 тис.9 років тому
RSW Solutions - If Possible Always buy OEM
RSW Solutions - How To Install Software
Переглядів 4,3 тис.9 років тому
RSW Solutions - How To Install Software

КОМЕНТАРІ

  • @projectdalekmark
    @projectdalekmark 7 місяців тому

    Fantastic video! Thank you. My ride height has a mind of its own and the car always wants to go to its maximum ride height. I've rebuilt the pump, valve block & whole suspension with new height sensors, air bags etc. Do you know what might be the problem.

  • @Yurmum1218
    @Yurmum1218 11 місяців тому

    I love you and your family mr Wilson

  • @shauntaylor9903
    @shauntaylor9903 Рік тому

    Why do I have to reactivate my product every time I use it???

  • @alhamedi66
    @alhamedi66 Рік тому

    Thank you for the video. Just finished purchase my EAS unlock V4 p38, and I hope it solve my problem with sir suspension otherwise I will delete all system and convert to coil spring. Peace of mind. Because I do everything to safe air suspension system but until now not working fine. Waiting my software and hardware.

  • @Maikon123456
    @Maikon123456 Рік тому

    I'm using the program and the error C1A00 appears and I have no idea what it could be

  • @ericmoreau6243
    @ericmoreau6243 Рік тому

    hello, I can no longer order on your site, all payments are refused

  • @BOOMSTICK-PRODUCTIONS
    @BOOMSTICK-PRODUCTIONS 2 роки тому

    Bro is MacGyver ! 🤙🏾

  • @Deltamoses
    @Deltamoses 2 роки тому

    How did you get the bolts out of your muffler flange on the exhaust swap video? Mine are rusted tight. Sorry I can't comment on that video.

  • @rmq2851
    @rmq2851 3 роки тому

    Great vid, Mr, Wilson. keep up the good work. I myself restore this great 4x4. I have 6 of them and restored them all. ;-)

  • @daflawlessstone5557
    @daflawlessstone5557 3 роки тому

    Omg can you please help me out how do I contact you guys

  • @finicottsflash4258
    @finicottsflash4258 4 роки тому

    Hi, love your videos very informative and helpful,, I have a 2010 vogue,, i had smart key not found up on dash yesterday and vehicle completely shut down,, was able to reset it by disconnecting the battery for a few minutes,, was wondering did you ever come across this,, any help would be greatly appreciated,, im afraid of this happening again, Thanks Finbarr

  • @thedoc8876
    @thedoc8876 5 років тому

    Hello, I was wondering what is the model of the Odyssey battery you are using in your Rover. I've had terrible luck with my Optima battery. I would like to switch batteries but need your advice on the Odyssey battery.

    • @teachingbees7048
      @teachingbees7048 5 років тому

      For the cost, I have not noticed any huge difference in performance. I would just go with the mid line AGM battery that is most easily accessible in your location in case of a warranty claim.

    • @thedoc8876
      @thedoc8876 5 років тому

      @@teachingbees7048 Thank you very much for the insight! I appreciate it immensely!

    • @eva4405able
      @eva4405able 4 роки тому

      Do you recommend any step for park and storing lr3 for longer periods. Like 1 and half year?

  • @matjenkins9025
    @matjenkins9025 5 років тому

    Sir I have a question about your video on cleaning the throttle housing. I have cleaned it now and wondering if I should put a drop of oil around the gasket ?

  • @asdf8592
    @asdf8592 5 років тому

    Can you make a video on why does the back door in a P38 doesn`t open in the first run and have to wait almost 40 min?

  • @talhakhalid9343
    @talhakhalid9343 5 років тому

    hello ! i have a problem in windows 10. in my pc the message is appear on screen that (cannot display This Video Mode Optimum resolation 1280x1024 60Hz).and my all deriver in updated.i have (i3 2nd generation 3.30 processor with 5 GB RAM)

  • @talhakhalid9343
    @talhakhalid9343 5 років тому

    hello ! i have a problem in windows 10. in my pc the message is appear on screen that (cannot display This Video Mode Optimum resolation 1280x1024 60Hz).and my all deriver in updated.i have (i3 2nd generation 3.30 processor with 5 GB RAM)

  • @steviesilvers
    @steviesilvers 5 років тому

    life saver cheers!

  • @trivigonzales
    @trivigonzales 6 років тому

    I emailed you cause i am interested in buying the product from you (08 range Rover Sport Supercharged) i sent the email to StoreyWilson@RSWsolutions.com But i still haven’t gotten a response Please contact me at trivig@yahoo.com

  • @eccosabanovic1589
    @eccosabanovic1589 6 років тому

    ..a lot of useful info about P38's here..thank you very much..i have replaced delay timer with standard yellow relay, in order to stop car from self aligning over night and now is staying properly high up in the morning..

  • @ShadowKeeper12
    @ShadowKeeper12 6 років тому

    Thank you Mr Wilson. Always love your videos on the P38’s. You are truly a wealth of knowledge. Take care mate. 👍

  • @khndenmark
    @khndenmark 6 років тому

    You are as always GREAT. We are many who loves the P38 and you are one of the best out there to explain and show what to do if there are problems. PLEASE PLEASE make more of these very informative videos. All the best from Denmark ;-))

  • @MrDarren251
    @MrDarren251 7 років тому

    Hi do you have one that will do the Fbh

  • @GilesDMT
    @GilesDMT 10 років тому

    Much obliged, Randy!

  • @stacifisher1036
    @stacifisher1036 10 років тому

    im having my suspension light coming on and i just bought this vehicle used from a car dealership and it didnt start happening til they put 2 new tires on them. can you give me any advice on how to fix it?